Downloads

1-1. Adjustment of the clearance of the rocking bracket.wmv
1-2. Adjusting of the front and rear clearance of the needle bar.wmv
2-1. Adjustment of the pressure of the presser foot.wmv
2-2. Adjustment of the adjusting device for the presser foot.wmv
2-3. Adjustment of the height of the presser foot.wmv
2-4. Adjustment of the height of the feed dog.wmv
2-5. Adjsutment of the horizontal level of the feed dog.wmv
2-6 Adjustment of the moving section of the feed dog.wmv
2-7 adjustment of rhe feed cam setting.wmv
3-1 The moving section of the mes setting.wmv
3-2 The thread trimmer cam setting.wmv
3-3. Check the operating status of the mes bracket.wmv
3-4. Replace the mes.wmv
4-1. Adjustment of the upper thread tension.wmv
4-10 Adjustment of the height of the Feed dog.wmv
4-11 The X-orign setting.wmv
4-12 The Y-orign (2070P) setting.wmv
4-2. Adjustment of the thread take up spring.wmv
4-3. Adjustment of the lower thread tension.wmv
4-4. Adjustment of the height of the needle bar.wmv
4-5. Adjustment of the hook time.wmv
4-6. Adjustment of the synchronizer position.wmv
4-7 Adjustment of the upper thread supplying wire.wmv
4-8. Adjustment of the moving section of the feed dog.wmv
4-9. Adjustment of the horizontal level of the feed dog.wmv
5-1. Adjustment of the belt tension.wmv
6-1. Check the lubrication.wmv
6-2. Check the hook lubrication.wmv
7-1. Head grounding.wmv
8-1 Replace the gauges.wmv
9-1. Adjustment of the position of the bracket solenoid.wmv
KM2070.wmv
Route upper thread.wmv