Downloads

_desktop.ini
1-1. Disassembly or assembly of the needle bar mechanism.wmv
2-1. The timing belt setting.wmv
2-2. The feed dog setting.wmv
2-3. The feed dog and the needle feeding time setting.wmv
2-4. The feed dog height and balance setting.wmv
3-1. The moving knife setting.wmv
3-2. The moving knife bracket setting.wmv
3-3. The lower thread catcher setting.wmv
3-4. The thread trimming cam setting.wmv
3-5. The thread trimming rocker link mechanism setting.wmv
3-6. The thread trimming solenoid setting.wmv
3-7. The moving knife shaft crank setting.wmv
3-8. Adjusting the operating of the thread tension adjusting device disk.wmv
3-9. The up and down stop position of the needle bar setting.wmv
4-1. Hook timing.wmv
4-2. Adjusting the height of the presser foot and the pressure.wmv
4-3. Adjusting the wiper location.wmv
4-4. Adjusting the tension of the upper thread.wmv
4-5. Adjusting the tension of the lower thread.wmv
4-6. Adjusting the opener location.wmv
5-1. The lower shaft spiral gear and the hook gear setting.wmv
6-1. Oil Supply.wmv
6-2. Adjusting the oil supply volume.wmv
6-3. Check of the upper shaft oil supply pump.wmv
7-1. Replacement of gauges.wmv
797_replacement of the needle bar and Needle Bar Releasing Pin.wmv